Author Topic: Automation 450 remake  (Read 388 times)

0 Members and 1 Guest are viewing this topic.

Offline KrazyK

  • Amiga 1200
  • ****
  • Posts: 313
  • Karma: 126
    • View Profile
    • KrazyK Remakes
Automation 450 remake
« on: February 18, 2021 »
Been putting this one off for a while as it after ripping the music and gfx it wasn't as straight forward as I thought it was going to be. 

Cracktro consists of the following:
Large disting logo
Rastered vu meters
Top and bottom 16x16 scrollers (ridiculously fast!)
64x50 central bouncing scroller
64x50 left vertical scroller- also rastered

I've tried to get the disting main logo as close as I can but could do better so this is the first versio before i try ot get it even closer to the original.  Not really a sine table as such to rip from the original prg file so i've created my disting effect.  I'll release the source once i'm happier with it.
And yes, the top and bottom scroltexts are really that fast in the original and pretty much unreadable - and the lower one is upside down too!
Let me know if it runs ok.

Attached the new version with the 1:1 sine wave table that I eventually managed to rip so it's identical to the original now. With the help of Grazey. ;D
I'll post the source in the Purebasic section when it's properly commented.
« Last Edit: February 26, 2021 by KrazyK »
Challenge Trophies Won:

Offline Dr.Death

  • Senior Member
  • Amiga 1200
  • ********
  • Posts: 441
  • Karma: 9
    • View Profile
Re: Automation 450 remake
« Reply #1 on: February 20, 2021 »
Runs perfect for me mate, well done and keep it up.
Proud member of DAWN