ok but i need after to sub 160 and 100 to center the whole stuff
- Welcome to Dark Bit Factory & Gravity.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
ASM / Re: help me release my 256b intro!
January 12, 2007
Thx for ur fast reply!
this demo will go on pouet, like my previous one (http://www.pouet.net/prod.php?which=25703), but wont be released in a party
no i dont think so, for each (x,y) point I calculate dist from the center which is diff for every points,
this demo will go on pouet, like my previous one (http://www.pouet.net/prod.php?which=25703), but wont be released in a party
QuoteAre you allowed to use 386 instructions (despite the fact this is real mode)?yep
QuoteTop of my head --- Is it possible to pre-load dist and/or ang outside your main loop?
no i dont think so, for each (x,y) point I calculate dist from the center which is diff for every points,
#3
ASM / help me release my 256b intro!
January 12, 2007
Hi guys, i'm new to asm and just started a 256b demo, I need some tips about optimizing and need to raise the exe size to 256 bytes (now it takes 292). Any ideas?
(it compiles with nasm)
(note that a few lines are missing since it not really finished, in the end it look a LOT better than that...)
(it compiles with nasm)
(note that a few lines are missing since it not really finished, in the end it look a LOT better than that...)
Pages1